Skip to content
MiloHax Guides MiloHax Guides MiloHax Guides

Santroller Powered Drums

Platform
Controller
  • Please note that your Santroller Configurator may have different settings, depending on how your drums were connected/modded.
    If you purchased your drums pre-modded or adapter pre-made, contact the seller for more information.

Setup

Section titled “Setup”

Be sure to [download the latest version of Santroller].
After that, start up Santroller.

In the start screen, select your Device to program, Connection Method, and Device to Emulate. This will depend on what device you’re using for your drums.
In the tutorial screenshots, it was a Raspberry Pi Pico, USB Adapter, and Rock Band Drums respectively.
After selecting your options, click on Configure.

Santroller's initial screen. 'Device to program' is set to 'Raspberry Pi Pico', 'Connection Method' is set to 'USB Adapter', and 'Device to Emulate' is set to 'Rock Band Drums'.

In Controller Settings, change the following:

  • Set Device to Emulate to Rock Band Drums
  • Enable Use USB Passthrough with RPCS3
Santroller's Controller Settings. The settings reflect exactly what is above.

MAKE SURE YOU CLICK ON Save Settings before closing the program or you will lose progress!

Santroller with a cursor is hovering over 'Save Settings'.

When you’re done, close Santroller.

You can now launch Rock Band 3!

[Back to Controllers]

Research by [Lynxeption], [gonakil1ya], and [SquidBoy425 (Team Oceanman)].
Special thanks to [@amphobius] for additional pictures.